600cc cartridge : Measure the actual cartridge weight.220cc cartridge : Hold the cartridge and shake little bit to feel ink flow inside.So please check the actual ink cartridge follow by below. Sometimes display shows there is enough remaining ink, but the actual ink cartridge is empty or very low. Please check if the ink remains inside the cartridge or not. Excessive head gap can cause ink mist to cure on the head surface. *If the head gap is larger than 2.0mm on materials, especially on reflective materials (like a mirror or shiny material) the nozzles can clog. The caps, table surface, and heads must be cleaned regularly. *This error is caused by poor air quality in the print environment or by inadequate printer maintenance. (Lint, dust, Ink mist, or cured ink by UV reflection might be the cause of this issue.) It might be caused by something inside of Inkjet Nozzle. (like more "Curly", "Dot line", "Half fired", or "Widely leaned" nozzles.) All ancillary text is grey to make the pure tested black stand out.Compare to "Nozzle deflection 1", nozzles are more badly deflected. Each tested color’s total surface area is 285.84mm² (which would be about a 16.9mm square, so roughly equal to one of the colors’ individual squares). The lines are shown horizontal, vertical and at 45 degree angles. The one I designed is specifically for a weekly test, and will point out ink/toner problems while not using much ink/toner.įor each tested color (cyan, magenta, yellow, black, magenta/yellow, cyan/yellow and cyan/magenta), it shows a series of 15mm lines at 2.0, 1.0, 0.75, 0.5 and 0.25 points.
It’s not comprehensive there are better tests out there for when you suspect something is wrong, for example it doesn’t test gradients. But with the new printer, I decided to design my own test page. This was a cropped test print I found online, and mostly did the job. I use to have a weekly test print sent to the Canon, to prevent the nozzles from seizing and to notice when the ink cartridges were empty. It’s replacing my old laser printer (Brother HL-2270DW) and inkjet (Canon MX922), the latter I got sick of being, well, an inkjet printer. This week I bought a new color laser printer, a Brother HL-3170CDW.
0 kommentar(er)
